How do I setup my Swann security camera network?

How do I setup my Swann security camera network?

Pair your IP Camera on Swann Security app

  1. Tap Menu (upper left) then select Pair Device.
  2. Scan the QR code sticker attached to your camera.
  3. Once you reach this, enter the WiFi password then tap Next.
  4. Enter your desired camera name.
  5. Set the camera to Pairing mode by pressing and holding the reset or pair button.

What is DST configuration?

The DST function allows you to configure your DVR to automatically ad- just its time for Daylight Savings in your time zone. You can set when daylight saving time starts and ends. Enable DST: Click the checkbox if you would like the DVR to adjust the time when Daylight Savings time begins.

What is the Swann admin password?

12345
The default, all-access username is “admin”, the default password is “12345”. To ensure your on-going privacy, we strongly recommend setting a password as soon as possible.

How do I change my Swann security network?

You can easily switch between AP and Station WiFi Mode by accessing the Monitor’s Main Menu > Network > WiFi Setting screen. If changing from Station to AP mode, you must also reset the camera to restore default AP Wi- Fi settings. Tap Scan. Select your Wi-Fi network from the list of available networks and then tap OK.

Where is the IP address on a Swann DVR?

You will find that in the network configuration menu of your recorder. 1) Take note of the IP address (IPv4) of the DVR when it is on DHCP mode. 2) Take note of the Gateway address (this is the address of your router on the network).

Is DST on or off now?

Daylight Saving Time begins on Sunday, March 14, 2021 at 2:00 A.M. On Saturday night, clocks are set forward one hour (i.e., losing one hour) to “spring forward.” Daylight Saving Time ends on Sunday, November 7, 2021, at 2:00 A.M. On Saturday night, clocks are set back one hour (i.e., gaining one hour) to “fall back.”

How do I find my Swann DVR password?

Resetting the password

  1. Get to the login screen on the recorder.
  2. Click on Forgot Password.
  3. Enter the MAC address that you took and replace ” – ” with ” : “. It should look like this – BC:51:FE:11:22:33.
  4. Click on OK once done.
  5. You then need to set your new password. Please follow your Wizard Quick Start Guide.